How to
Nebula/Pure controller will start when you press the HOME button or connect to computer by USB cable. If it cannot
stop working after a long time, please plug the USB cable in computer then pull it out, thus it will be power off.
Please disconnect z when stop playing with the controller, then it would turn off automatically. If the LED light
remains on, it may because it’s still Bluetooth connect.
You can restart it by pressing the RESET hole on the back of the gamepad with a pin for 5 seconds, the gamepad
would get reset.
Charge the controller with the USB cable or charging dock.
When charging, the light bar will be flashing orange; when fully charged, the light bar turns off
If you find your mic does not work when connecting the headset to the controller. Please set it in the PS4 console.
Setting -> Devices -> Audio Devices -> output to headphones -> All Audio blinking slowly then LED 1 in the controller will be blinking slowly after the controller is connected to the console.
Connect the controller to the Windows PC via a USB cable.
Under normal network conditions, Windows will automatically download the required drivers.
Troubleshooting
First of all, you should check the number of Bluetooth devices in PS4/PS3 and delete unnecessary devices
When connecting PS4/PS3 for the first time, you should use Mirco USB cube to connect first, and then you only need to wake up the host with one key when using it again.
If you have checked the above issues and still cannot connect to the controller, please contact your customer service representative and support team
Usually, you can connect to a Windows PC without manually downloading drivers. Please check that your PC USB port and controller are turned on. If still unable to connect, the gamepad driver is available on the internet.
Note: With vibration function but without motion sensing function under X-360 mode
wired connection